Pitch detector › BPM counter
BPM counter: tap the beat or let it listen
Tap the pad, or any key, on every beat of the song: the counter shows the tempo in beats per minute (BPM) from the fourth tap and steadies with every tap after that. Or switch to Listen, allow the microphone and play the song out loud: the counter finds the beat by itself, often within about ten seconds for music with a clear beat, and shows half and double time beside it. Nothing is recorded or uploaded.
--BPM
Tap along with the beat of the song: a reading appears after four taps
The reading is a straight-line fit through all your taps, so one early or late tap moves it very little. Pause for two seconds to start a new count.
Last updated:
How to tap tempo accurately
Tap on a sound that falls on every beat, usually the kick drum or the snare, rather than a melody that moves around it. Eight or more taps give a steady reading. The counter fits one straight line through all your taps, so a single early or late tap moves the reading by a fraction of a beat per minute instead of making it jump. Stop for 2 seconds and the next tap starts a new count, which is how to measure the next song.
How the BPM detector listens
In Listen mode the page looks for onsets: the moments when the sound suddenly gets louder in some part of the spectrum, such as a drum hit or a strummed chord. About 90 times a second it splits the sound into 36 frequency bands from 40 Hz to 11 kHz and adds up how much each band rose since the moment before. Every half second it checks which repeat period, between 60 and 200 BPM, lines those onsets up best over the last 8 seconds. When four checks in a row agree within 1.5%, it calls that the beat.
Half time and double time
A beat that repeats every half second fits 120 BPM, but it also fits 60, counting every other beat, and 240, counting every half beat, and people often feel the same song at different levels. When two readings fit the music about equally well, the detector leans toward the one nearer 120 BPM, then shows half and double time beside its answer so you can pick the one you count. Tapping has no such choice: it counts exactly the beats you tap.
When it cannot find a beat
Music without a steady pulse, such as a solo piano played freely, an ambient piece or a song that speeds up and slows down, has no single tempo to lock on to. Very quiet playback, a noisy room, or music playing only in headphones also leave the microphone nothing to count. After 30 seconds without a steady beat the counter says so; tap along instead.
How many taps do I need?
4 taps give a first reading, and every tap after that steadies it. The counter fits one line through your last 32 taps and shows how many it is using. If the song changes tempo, pause for 2 seconds and start a new count.
Can it find the BPM of a song I am playing?
Yes. Play the song out loud from a speaker, a laptop or another phone near the microphone, then press Start listening. If the song only plays in your headphones or earbuds, the microphone cannot hear it, so tap along instead.
Can I upload a song file?
No. Nothing leaves your device: the counter either listens through the microphone or counts your taps. To measure a file, play it out loud near the microphone.
What does BPM mean?
Beats per minute. At 60 BPM there is one beat a second, at 120 BPM two. One beat lasts 60,000 divided by the BPM, in milliseconds, so a beat at 120 BPM lasts 500 ms.
Does it record me?
No. In Listen mode the beat is worked out in your browser from the microphone and each slice of sound is thrown away as soon as it has been measured. Nothing is stored or uploaded. Tap mode does not use the microphone at all.
BPM here means the tempo of music. This counter does not measure heart rate. For the exact note of a sung or played tone, use the pitch detector.